Rear Arm Mods for DBK2600KIT
Drill original handbrake cable hole out to 22mm (Tip: we use a step drill for this)
Grind ridge off rear arm for the h/brake cable to pass through so it doesnt rub on it.
Grid welds just to tidy up (Use a flap disk for a clean job)
Cutt off all original brake brackets
Using the supplied brake line clip holder, mark the arm with a scripe and drill a 6.5mm hole.
Using the below pictures as a reference drill and tapp a M6 hole in the arm (This is for the saddle clamp to hold the handbrake cable away from the rear flange once installed.
